A 2D array X(7,9) is stored linearly column wise in a
computers memory.Each element requires 4 bytes for the
storage of the value.If the first byte address of X(1,1) is
3000,what could be the last byte adress of X(5,8)?
Answer Posted / a.divya
no of bytes=4
column size=9
address of the first byte =3000
last byte of address x(8,5)=3000+4(9(8-1)+(5-1))=3268
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the difference between earth leakage and earth fault?
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
which book to refer in electrical engineering for iocl exam & which book for general english.
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
how to calculate the earth fault current
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
mention hazard experienced during installation
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
What is the disadventage of gland earthing(power cable) if any. ?
What is depreciation factor?
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.