Interested to Buy Any Domain ? << Click Here >> for more details...
different between circuit breaker & switchgear & relays
- 6 Answers
- 37388 Views
- EFS, I also Faced
- E-Mail Answers
Answer Posted / deepak
relay is a sensing element which senses the fault ant then sends a signal to circuit breaker.....
circuit breaker after receiving the signal from relay..trips and hence protects the apparatus/device to which it is connected
switch gear is a series breakers connected together to
form a complete protected bus bar with many inputs outputs.
deepak7rules@gmail.com
| Is This Answer Correct ? | 38 Yes | 1 No |
Post New Answer View All Answers
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
how to modify DOL control panel into Delta Y connection?
Which capacitor is preferred for high voltage and frequency?
How i can decide that HVDC line is best for transmission.
draw singleline diagram of star to delta and dol starters
How to know of any cable size if there are not written on cabl?
how to find the resistance and gap volatage of the diode??
What is a slack bus?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
Give the topology of current amplifier with current shunt feedback?
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
