Interested to Buy Any Domain ? << Click Here >> for more details...
Explain the Term in CT Name Plate – Class: 5P10
- 6 Answers
- 29522 Views
- Jindal, SRES, I also Faced
- E-Mail Answers
Answer Posted / sangram
first i explain the term:- 5 is a class of accuracy, p you
should use for protection purpose, 10 you should load up to
10VA.
you should use this CT for protection purpose, and the
burden rating should 10volt Amp at 100% load pass in
primary, you should allow +/-5% error for this CT.
| Is This Answer Correct ? | 14 Yes | 7 No |
Post New Answer View All Answers
what is the efficiency of thyristor
State the formula for overall efficiency of thermal power station
What do you mean by cogeneration? What its working principle?
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
Hi,iam a diploma in electrical engineering.rtd from indian air force in apr 2007.prsently working in reliance next link as a network maintenance engineer since 2007,can i get a job in motherson sumi.
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
why the name trunking bus PT
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
What is the name of the winding from which the supply is taken for load connections?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
What is the disadventage of gland earthing(power cable) if any. ?
What is Diff btw Fire Alarm & VESDA System???
what is the difference between switch yard to residential area.and how much required it.
