Interested to Buy Any Domain ? << Click Here >> for more details...
What is the comparision (advantages / disadvantages) of
110V, 60 Hz system to 230 V, 50 Hz system.
- 2 Answers
- 8732 Views
- I also Faced
- E-Mail Answers
Answer Posted / neeraj pandey
110 Volt, 60 hz system havin the major advantantage of
safety. 110 volt shoch is not dangerous for human.
But the disadvantage is, it requires more conductor as for
same power current is increased.
in 230 Volt system, electrical shock is dangerous for human
but it saves the conductor for same power.
| Is This Answer Correct ? | 20 Yes | 5 No |
Post New Answer View All Answers
Can u tell me design of switch yard
what exactly commisioning work does in electrical site work... LT side?..
What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
what are the installation procedure of high voltage power transformer,CT,CB&PT?
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
What is The Resistance Formula
should %impedance be high or low in a power transformer? if so why?
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
what is advertised hop count
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
how to select rating of HT Panel
