Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / iamdon
CT is used mainly for Instrumentation(Measurement and
protection system) purposes that is why it is also termed as
instrument transformer.The measuring and protecting devices
are not rated to sustain high currents.What a CT does is,
it lowers the current in secondary side so that measurement
as well protection can be done at a reduced level of
current.
The digit in CT ratio of secondary side is IS standard for
rated secondary current so that uniformity among manufactures
be established.
The various values of secondary currents are
1)in the range of 0-5 amp e.g, 1A,5A
2)in the order of mA(particularly 40mA)in case of digital
devices for measurements and protection.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
what is the chiller and working principal
How to choose size of the cable w.r.to current carrying capacity ...
Why squirrel cage motor can only use with low starting loads ?
please send me the L&T Emb. sys. placement papers and entire details of pattren
How to calculate the fuse rating depend upon the DC circuit?
what is W.T?specify the acceptable range?
What is the formula to calculate a three phase alternator
how single phase preventer works ?
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
how to calculate fault level?
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
during installation time of transformer and alternator which points we have to observed?
