. Why the transmission lines are in 11kV, 22kV, 33kv, and
why not 10kV,
20kV, 30kV?
- 3 Answers
- 9330 Views
- I also Faced
- E-Mail Answers
Answer Posted / vasudevan
Form Factor is 1.1 which is multiplied bu 10 or 20 or 30
kV. Then the result will be 11 or 22 or 33 kV.
| Is This Answer Correct ? | 26 Yes | 4 No |
Post New Answer View All Answers
Which material is used for the core of a transformer and why?
In EB metering we face problem kva jump even in no load condition.can any one help to control this
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
Why neutral cable carry current.
derive DC RMS value for half wave rectifier?
wat system call?
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
why the carbon brushes are broken in srim while the motor runningtime
if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer
What is the maximum operating temperature for a thermoplastic insulated cable?
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
What happens when two positively charged material is placed together?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
WHY RATING OF VCB NOT LESS THAN 630A
