Interested to Buy Any Domain ? << Click Here >> for more details...
why most of the induction motors are delta connected?
- 7 Answers
- 28133 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh lokhande
Elaborating in furhter to previous answer.
In Delta connection
VL = VPh
VL - Line voltage
Vph - Phase voltage
& IPh = IL / 1.732
IL - Line current
IPh - Phase current
Hence Phase current is less compared to star connection
where line current = phase current.
| Is This Answer Correct ? | 17 Yes | 13 No |
Post New Answer View All Answers
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
how can we make cable shedule for controll wiring ? which details must be required for it.?
why effective resistance should be more than static resistance in transmission line?
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
Why is voltage is required to be within permissible range for an electrical equipment?
What is the difference between Static and servo controlled voltage stablizer?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
I need bhel electrical test pattern & paper
Why power factor should not be in leading (capacitive) mode of any load.
How Calculet The UPS AH In Load
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What types domain of laplace transforms? What behavior can laplace transform predict how the system work?
what percent do you derate your copper wire when you change from copper buss to copper wire
how to find the multiplication factor for digital energy meter and analog energy meter
