Questions :-
HR-
Q.1 about yourself & family background ?
Q.2 Why u choose Power sector as ur carrier starting not any
other sector ??
Q. 3 What think abt NTPC ?
Techincal Questions:-
Q.1 about Vocational Training……What u did , see the main
equipments….etc
Q.2 Why a transformer Noise during its running condition ?
Q.3 about transformer oil material & Test name for the
measurement of its dielectric strength & wht will u do if
its dielectric strength goes low ? ……..some discussion type ?
Q.4 What is relation between transmission lines &
Communication lines ?
Q.5 Which Machine u will prefer to use at a place where
flammable gases are coming out & why ?
Q.6 how fault in an electric system is detected & hw
protection of equipments is done ?
Q.7 Why we didn’t feel electric shock in an electric train ??
Q.8 Anything u want to ask from us ??
- 44 Answers
- 39129 Views
- Akona Engineering, Bhel, BSES, Cranex, DRDO, JCB, NTPC, I also Faced
- E-Mail Answers
Answer Posted / ajit singh
please send me these ans on id ajitsinghkhariya85@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
what is the voltage between earth to neutral in lift.
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
why i can not use thimble on capacitor duty contactor
Why air circuit breaker off due to power failure?
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
how to avoid Saturation in C.T?
placement paper samples of mspl company
What is cut-off rate?
how to store the thunder power?
Explain Creepage Distance of Insulator
