Interested to Buy Any Domain ? << Click Here >> for more details...
Why is it that North America uses 60 hz frequency while
Europe uses 50 hz?
- 4 Answers
- 9270 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh lokhande
Basically frequeny of supply depends upon generated voltage
frequency which is guided by universal formula
N=(120*F)/P
Where;
N = Synchronous speed of Generator
F = Frequency
P = No of poles of generator
Frequeny in North America is 60 hz because designed
generators are for 60 hz as per above formula and vice
versa for Europe.
Hope this is clear.
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
Differentiate between digital phase converter and ordinary phase converter.
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What are the transformer losses?
hi can anyone pls tell me the eee interview core questions asked in l&t
Why cables and busbar both needed in LT Panels?
what r substations?what r there work?why voltages r incresed and then reduced during distribution of power
What is different between Circuit breaker and Isolater?
What is the difference between diode and a transistor in terms of the direction of current flow?
When MICC cables used ?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
