I need the intools training institute address in india.
Intools subject oriented local authors books.Refer me plz
- 3 Answers
- 11676 Views
- I also Faced
- E-Mail Answers
Answer Posted / ibrahim
I want the address of the intools training center in india
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.
whats the abbreviation of IOP? is it instrument of power or input open problem?
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
what is interlock system and why we use of this?
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
what is the difference between active & reactive power?
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
Why grounding is necessary? Give example with diagram.
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Which type of pressure can be measured by primary elements?
What is voltage regulator?
How to calibrate Magnetic flow Transmitter in Field
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
