Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE FUNCTION OF BALANCE LEAK LINE IN BFP
- 2 Answers
- 18817 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / sajeedmon t
In any centrifugal pump the difference between the amount
horse power put into the pump shaft by the driver and the
amount delivered by the pump is absorbed in the pump in the
form of heat.This difference is greatest at low capacities
and makes it necessary on multistage unit to provide for a
minimum flow through the pump to carry of excess heat and
prevent overheating and flashing of the liquid in the
pump.minimum flow is best insured by a by-pass installed
between the pump discharge and the first valve and connected
back to the source of suction supply.This bypass may be
manually or automatically operated,but it is highly
important that the line be open during periods of light load
| Is This Answer Correct ? | 9 Yes | 32 No |
Post New Answer View All Answers
How does pressure transmitter electronics sensor be used to transmit level measurement parameter?
how to find rmc plant MD?
Can any One Help me to Know about Fire hydrant and its related water Pressures
What is quality management system?
Let’s say we live in a country that gets very cold, in Northern America / Europe. In winter, we monitor the ouside temperature, so that heaters can be switched on, inside the house. The idea is that, the colder it is outside, the warmer it should be inside. The heating side of things is just a heater that is either switched on, or switched off. Just from the information that has been given, please discuss this matter in depth. Provide reference to OPEN / CLOSED loop control, FEEDFORWARD / FEEDBACK control and MODULATING / ON_OFF control raised in the discussion.
Why virtual corporation is used?
what is a benifit to configure site to site vpn ?
What’s the normal transformer current rating?
Write a C++ code that print the largest two among three numbers
why we use log files in QTP?
What is fauit level
What kind of tools and materials are required to test water softening system of heating plant?
What happen if we install flow meter with orifice plate, but bevel position is in upstream and not in downstream
What causes little rust pockets to pop through or off concrete cylinder blocks (home)?
what is load capacity of 11 cm cylinder bor 100kg. pressor?
