Interested to Buy Any Domain ? << Click Here >> for more details...
Why OLTC(On Load Tap Changing)transformer is not recomended
for improving voltage instability?
- 2 Answers
- 6278 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
Voltage instability is due to following reasons:
1)Gradual increse in load.
2)Loss of generating unit or heavily loaded line
3)Poor cordination amoung control action to avert the
situation etc.
In all the cases the system is insufficient to cater the
reactive power requirement of the load.It leads to the
reduction in voltage at load end.
OLTC transformer increases the voltage level at load side
so Q requirement of load increases.The system is already
running short of Q, so it is not possible to supply this
incresed Q by system.This leads to more voltage dip at
load.In this way, instead of stabilizing the voltage, OLTC
transformer aggerevate the voltage instability.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
How to run a three phase motor into single phase........
what is th basic difference between a d latch time line and a d flip flop time line???
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
Is it possible to connect a safety device in to parallel?
What are the advantage of free wheeling diode in a full wave rectifier?
33kv substation lay out details & line to line & line to earth measurements
What happen to generator if i have unbalanced load?
What is difference between Sample test and Routine test in safety standard?
explain wiring system
how to calculate the lightning arrester conductor @ no of earth pits required
What is the name of the winding from which the supply is taken for load connections?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
Define super node?
