Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / venkat
Transformer test are,
Insulation Resistance Test,Voltage Ratio Test,Magnetic
balance test,Vector group Test,Magnetising Current
test,Short Circuit Test,Oil Test
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
draw the block diagram of fire alarm?
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
how to commissioning the genset with amf panel?
Witch do depand of Power factor and theory of power factor?
How isolater function when installed inelectrical 440V wiring
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
What are the applications of different multistage amplifiers?Plz also write advantages of these amplifiers? Thaaaaaaaaanx
how to ctrl motor by use of ac or dc drive.plz explain evdintly
Why we make earth connection with Transformer Body and What will be the minimum size of copper wire as per code with respect to KVA rating of Transformer?
How REF protects transformer alone? explain with diagram.
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
how will we calculate the copper wire load..
