Why generally the transformer primary is connected in star
& secondary in delta
Answer Posted / naresh
transformer generally consistsof primary star connected &
secondary delta connected.star connection consists of 3
phase & 1 neutral wire ,so that each phase voltage is equal
to1.732 times the line voltage.similarly on secondary side
more current is required to drive the load ,it is provided
by delta connection,phase current =1.732 times line
current.for this reason transformer is connected so.
Is This Answer Correct ? | 17 Yes | 7 No |
Post New Answer View All Answers
what is effect of leading power facter on the system and billing
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
How do we calculate the resistance per metre of single core aluminium stranded cable 19*3.25mm sheathed in pvc,at 15 deg C temperature?
Lt motor sfu flashing reasons?
How to check the LM324 Ic
Why an ac systems are preferred over dc systems?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
Name two types of electrical analogous for mechanical system.
full form of electrical?
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
What is the formula of frequency ?
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain