Interested to Buy Any Domain ? << Click Here >> for more details...
why the tapping of transformer on ht side??????
- 12 Answers
- 41783 Views
- CTS, OPTCL, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / swayanjit ray
generally tappings are provided on the HV side because on
the HV side of the transformer less current is flowing so
that whenever we change from one tapping to another less arc
will created as compared to LV side. again we can achieve
the better voltage control by providing tapping on the HV side.
| Is This Answer Correct ? | 22 Yes | 1 No |
Post New Answer View All Answers
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
When can we take Neutral as common neutral link?
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
Can you explain about TEE protection scheme?
list the type of vfd? wich is sutable for heating kiln?
In siemens PLC, why do we want to move the data ?
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
what is the requirement regarding earthing of Single conductor with AWA
What is the test block protection relay if any body know plz explained
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
What are the electrical engineer roles and responsibilities in chemical plant?
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
What is Anemometer used to measure?
