Answer Posted / nishad
See, Battery chargers are mainly useing for charging the
battery bank which is responsible for all control supply of
control systems such as breaker clossing coil, trip
coil,indications, protection relays, Annociators etc....
Mainly, If we are taking the supply from main, ( with
out battery back up)at the time of power failer /
breakdown how will record/ reccongnise the problem.
Secondly, Normaly we are using DC power for control.(
AC also using) for desired DC back up we can store the
supply in Battery. But inthe cause of AC how it
possible!!!!!
Moreover, in the cause control system, DC is more
efficient than AC
well, if any body can give another good answer, Most
welcome to Him. Because Knowledge is Power.....
Is This Answer Correct ? | 31 Yes | 5 No |
Post New Answer View All Answers
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
3phase cable calculation formula by motor load
What is the difference between PLC and Embeded system
what are the analog quality input for protection function?what are minimum reqiments?
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
Define thermal resistance in the context of power amplifier.
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
explain working principle of earth leakage relay
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
Why generation voltage in thermal power plant is between 11kv to 33kv?
how is control wiring coding is done in a CRP panel ?
sometime battery charged and then automatically charged when rectifier ON conition, is there any chances please clarify the same.