Answer Posted / shwan
1- ball bearing
2- rolling bearing
kinds depended up on :
-pressure
-velcitty
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Why cad cam is better field against IT field?Is the salary is good in this field and if it so then what is the average salary in this field because I don;t think that salary is good enough in this field.
What is the jet plane?
What is endurance limit and what is its value for steel ?
A very strange fault i cam across today,that i never experienced not studied before, i need an answer for this. Phase to phase or line to line , L1,L2 & L3, voltages are 490VAC, but if i use line to ground , its again 490 VAC. . . whats the fault and theory behind of it?
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
How much calorific value of heat is needed to heat 00c of
What is the gas constant r for air?
what will be the minimum bearing clearance that after it will not profitable for machines?
hii sir. how will CAE/CFD courses useful to B.tech freshers? is this courses useful to getting job in automobile industry? plz give some advise...
What is coaxing ?
What is a uniformly distributed load?
WHAT MADE YOU BECOME AN ELECTO-MECHANICAL ENGINEER?WHAT IS YOUR JOB DESCRIPTION?WHERE DO YOU WORK?WHAT ARE YOUR JOB RESPONSIBILITIES?WHAT IS YOUR WORK ENVIRONMENT LIKE?WHAT IS YOUR EDUCATIONAL BACKGROUND?WHAT COURSES DID YOU NEED OR ARE VALUABLE FOR YOUR POSITION?WHAT ARE THE ADVANTAGES OF YOUR JOB?WHAT ARE THE DISADVANTAGES?WHAT MADE YOU GO INT THE FIELD?HOW MUCH SCHOOLING DID YOU NEED?WHAT DID YOU NEED TO STUDY?
plz send me paper of mppgcl 2008 or experience posted by any candidate
What are the causes of L.O. high temperature?
What kinds of pipes are used for steam lines?
