Interested to Buy Any Domain ? << Click Here >> for more details...
What are the methods used to improve powerfactor ?
- 6 Answers
- 10338 Views
- I also Faced
- E-Mail Answers
Answer Posted / bala sundaram
synchronous motor is used to improve power factor method and also capacitor.
when:
a synchronous motor working on no load in over excitation means it is possible.
how:
when current is lead the voltage power factor will improved.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
What is different between Circuit breaker and Isolater?
The screw thread commonly used for transmission of motion is one of the following types of threads
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
hi friends how 3 phase converter functioning ?what is working principle of rotory phase converter ?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
Should power factor be low or high?
Draw a SLD of DG distribution up to main LT panel?
Why can't we parallel the secondary circuits of two voltage transformers?
For some transformers we are using solid neutral earthing while some others we are using resistance earthing why ?
