Interested to Buy Any Domain ? << Click Here >> for more details...
In which reason, one end of CT secondry get connected with
Earthed? Normaly S1 of CT. Why????
- 1 Answers
- 5772 Views
- I also Faced
- E-Mail Answers
Answer Posted / dharmaraj.m
If suddenly CT secondary open means,at the time high
voltage produce in the CT sec.side.so that CT sec.connected
to earth. and which equipment u want to prtotect that side
connect the earth.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
How to calculate the input cable rating for 10kva ups (3phase input and single phase output and also 3phase output, battery rating 65Ah)provide the formula also.thnx
What is meant by reactance voltage?
What is force on a conductor in a magnetic field ?
why dc is used in control circuits for MV & LV switchgeras instead of ac
is that any software calculator to calculate the size of cable
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
i want to know about torque of slip ring induction motor
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
Why generation voltage in thermal power plant is between 11kv to 33kv?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
electromechanical relay type identification example : type=tjmh t-stants for j- m- h-
what is meant by tranformer impedance?
