Interested to Buy Any Domain ? << Click Here >> for more details...
what is the working principal of air compressor?
- 5 Answers
- 11567 Views
- Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / prabhjot
Electric motor gives drive to the Crankshaft through set of belt and pulley arrangement . To crankshaft further connected pistons in the cylinder, it sucks atmospheric air which is at low pressure through suction valve and converts it into pressurised air .This pressurised air through discharge valve goes into accumulator tanks or air receivers. From where we get high pressure air.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
i am a mechanical engg. student(fresher) . i am in kolkata. i want to prepare for govt. jobs like railway, ongc etc can anyone plz suggest me the good coaching for this in kolkata
Sir can u send me few interview questions and answers based on Deputy Superintendent(materials) of APSRTC. I have selected in written.reply to bhanudammoju@gmail.com thank u.
how the material no. 2062 will mild steel of desity 7.85? what are the other codes?
Please tell about the water type h.v.a.c with it's cycle and functions of each parts ?show me how talented u r?
We have 6-axis wotan horizontal milling & boring machine. Linear axis- x,y,z,w & U. Rotary table B Axis Z,U & W axis are parallel. Z is tool axis. X is cross slide. We wish to retrofit the machine.Which control I should select & also suggest How many axis simutaneous control for linear & circular interpolation.
What is the purpose of ventilation in the battery room?
hi i m Divyen . i have completed 10+3 in diploma in mechanical Engineering. so can i apply for student visa for canada?
how we calculate the induced air capacity of id fan of a boiler?
What should you do before you start the engine?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
we use parallel flow heat exchanger to coo oil of 1000 EP viscosity,oftenly tubes may damage during cleaning etc what is proper way to clean cooler? How impurities decreased or vanished during working or in less teme job performed?
State newton's three laws of motion.
How will you create a piston head?
How much pressure on air reservoir?
Is copper tube withstand under hard water say as 500 TDS.And is it cleanable by solfamric acid or by tube brushing
