for measuring current and etc.,why we use value of 1.732 in
three phase calculation. not in single phase.why
Answer Posted / prathap
in single phase system power P=V*I*COS(pi)where
V=voltage,I=curent,but in 3 phase system P=root(3)V*I*COS
(pi),(root(3)=1.743)
Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
what is model question rrb junior engineer electrical gr.II
in science exhibition how lamp can blink when you clap near the lamp ? thank you
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
what will happens if one phase is missing for 33/11kv power transfomer and why?
why electronic instruments is more favorable than electrical?
what is inverter and converter
hi friends how 3 phase converter functioning ?what is working principle of rotory phase converter ?
What is thresh hold value of current?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
What is time invariant system?
why do we use 25kv supply for traction purpose?
Convert a star connected network into a delta connected network.
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit