1.How a chlorine leak is detected?
2.What would happen if excess chlorine is added to water in
cooling tower?
Answer Posted / tushar patel
Chlorine Leak test the cylinder by spraying an ammonia
solution onto the cylinder joints. A leak is indicated by
white
cloud or mist that is formed when ammonia reacts with
chlorine.
Chlorine is heavier than air – an important point to
remember in the event of a leak.
Is This Answer Correct ? | 17 Yes | 1 No |
Post New Answer View All Answers
How can you determine the largest impeller that a pump can handle?
What is the maximum permissible Earth to Neutral voltage in an electrical system.
What is a common source of error in determining the percent spent caustic in refinery applications?
If sum one has HAL placement paper plz mail me ,I m Chemical Engg.my id is er.kotnala@gmail.com
What is the maximum recommend pipe velocity for dry and wet gases?
What type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha (net positive suction head available)?
what is R1,R2,R3, R4........?
The job profile as a Service Engineer?
if i added hypo before DM plant so i will affect my resins of anion or cation. if affect it so do prevent what kind of step should be taken to remove hypo before DM inlet?
What is carbon sequestration?
What are some guidelines for designing for liquid and gas velocities in process plant piping?
Why whenever a reciprocating compressor is switched ON or OFF it is put into unloading mode?
Mention some of the specialized crushing methods?
Are there flow velocity restrictions to avoid static charge build up in pipelines?
What is a black body?