Interested to Buy Any Domain ? << Click Here >> for more details...
why electric shock due to dc is dangerous than that of ac
- 44 Answers
- 69888 Views
- I also Faced
- E-Mail Answers
Answer Posted / emmanual
At 300V DC the shock may be same as 150V AC shock. THis
means that AC shock is more dangerous than DC.
On the other hand, it is the current produced that causes
you to get a shock. Therefore if 300V DC has 32 amps and
150V AC has 12amps then 300V DC will have greater shock
effects on you than 150V DC.Or if 150V AC has 32 amps and
300V DC has 12 amps of current then 150V AC will create
more shock than 300V DC.
Thus to conclude, do not try anythng unless you are not
sure of the current that is present or going to be produced.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
Write a note on Treatment for electric shock.
i need of the bhel question papers along with answers and also give some website names for the downloading question (electrical and electronics engg question)please help me....
briefly explain principle of resistance welding
What happens if the series current double?
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
can anyone send me some sample question regarding power grid corp
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
What are the advantages of nichols chart?
How we can come to know the substation range,without go through any name plate ?
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
in dc shunt motor if field winding is shorted then
Explain what are inter-poles and why they are required in a dc machine.
