please can anyone tell me in detail, what's mean by open
loop and close loop?
- 6 Answers
- 10825 Views
- I also Faced
- E-Mail Answers
Answer Posted / senthil.doosan
example for open loop - u can only monitor the output of
the transmitter(pressure,flow,temp.level)
example for closed loop-u can monitor the output of the
transmitter (pressure,flow,temp.level) and u can control
the process by using these parameters feedback by final
control element.
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
What is the Working principle of Dozing valve?
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
principle of dead weight tester ?
plz send me general of ongc
please send data bank of quetions answers on analytical instrumentation.
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
send me last 5 years questions asked in rrb chennai, for section engineer
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
can any send me a forbes marshall dtron 316 manual
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
