why fuse is not applicable for nutral and what will happen
when it applied.
Answer Posted / avd
It is basicaly for safety and easy diagnostic purpose. If
neutral fuse is provided, it will blow during fault but
phase supply will be available at fault point which may be
harmful during checking.
Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
how the phase convertor changes the no. of phases
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
sometime battery charged and then automatically charged when rectifier ON conition, is there any chances please clarify the same.
What aturn on methods of scr?
What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1
Salient pole alternator is more stable, why?
What is the difference between multimeter
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
What should be current in the Primary and secondary side of 1000KVA (11KV Supply)Transformer.?
Compare jfet’s and mosfet’s.
how to set the time in digital timer ?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?