Interested to Buy Any Domain ? << Click Here >> for more details...
can any one tell leakage class in control valve depend on
which parameter and there is any specific table or chart for
selection of valve leakage class
- 2 Answers
- 6077 Views
- I also Faced
- E-Mail Answers
Answer Posted / vaibhav v t
Leakage class does not depend upon any process parameter.It
depends upon user/process requirement.required Shut-off
condition is the parameter and selected trim type and MOC
are parameter upon which leakage class depends.
For detail refer hand book on Control valve by fisher.It is
available on internet.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
Calibration procedure for electro magnetic flow meter
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
key phaser where is use and work
what is compensation? temprature & pressure
protection relay watchdog contact operation?
How earthing can be checked????
it is possible to check the fail safe condition in pressure transmitter. if possible how?
components of control circuit belongs to control valve
What is the minimum rating availalbe for weld neck orifice in market?
Galvanizing.
what is interface level and how it is calibrate?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
