Answer Posted / hemanth
Ohm's Law is APPLICABLE only WHEN TEMPERATURE IS CONSTANT..
| Is This Answer Correct ? | 27 Yes | 2 No |
Post New Answer View All Answers
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
what are the application of over current relay?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
Thumb rule of cable size(rm>30 rm)X multiplying factor=ampere
wow to calculate the transformer rating(KVA)
What is systematic error?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What is a compensator?
how to select the isolation tranformer for siemens 802dsl cnotroller
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
State the formula for overall efficiency of thermal power station
Why AC current leads voltage in capacitor and how?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
