Why do we use solid shafts for transfer of power in case of
pumps/ turbines & other machines why we use a hollow shaft
(pipe) in universal joints of automobiles; although the
rated load and twist is approx. the same?
Answer Posted / vishnu
B'coz the hollow shaft can able to transmmite more torque
as comparing to solid shaft
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Can anyone suggest me how to learn Computational Fluid Dynamics? (I am just a beginner.)
Why do you want to leave your last job?
Metals, in general are of low strength and do not possess required physio-chemical and technological properties for a definite purpose. Alloys are therefore more than metals alone. Discuss the arrangement of atoms and structures of alloys.
How are the pneumatic system and the hydraulic system similar?
A fan is handling hot air at 285 degC with flow of 411635 m3/hr, power consumed is 1165kW and efficiency is 66%. what will happen to flow, power and efficiency of the fan if a water spray system is introduced to reduce the air temperature up to 200 degC? (also please refer any document regarding this)
What causes cylinder liner-wear down?
What are the different types of bearings?
hi this is swaroop i appliled for masters in us for mba and my ielts score is 5.5 and no gre and i have 14 backlogs
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
Is there significant affect on the output of modern gas turbines due to low frequency.
Dear all i have applied for section engineer post in RRB Chennai can anyone please send previous question papers please do it if u have
What is the maximum cylinder head temperature of a 1200 KW, 12 cylinders DG set
what is procedure of measuring operating length of mechanical seal .(in case of centrifugal pump)?
what is the function of platern water wall in a boiler? and difference between with ordinary water wall?
Hindustan petroleum placement papers.please send me.