Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / najib
Ward Leonard method is a very effective method of speed
control that allows the variation of speed both above and
below the base speed.
The speed control below the base speed is obtained by
varying the supply voltage to the armature of the motor.The
point important here is till the base speed the speed
control is constant torque and variable power method.
The speed above the base speed can be obtained by reducing
the flux of the field and it is a constant power and
variable torque method.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
whats the existence of reactive power and when it arises?
According to underground cables a) stress b/w sheath & conductor is high b) inrush of core & conductor
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
What is ST and specify its range of voltage.
What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
how much flux density of CRNO core
A parallel flow heat exchanger will perform better than a counter flow heat exchanger. State if the statement is true or false.
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
why on axial hitting up of air blast on hydrogen produced in oil circuit breaker,temperature rises of the core of the arc?
how harmonics generated in induction furnance? how minimise it?
if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
