a 3 phase motor was running with delta connected, suddenly
one phase winding got burnt off, what will be the effect ?
Answer Posted / najib
There are different situations in which this question can
be looked into.
Case 1.The motor is lighly loaded
In such a case the motor shall continue to run at the same
speed without any hiccup.
Case 2.The motor is supplying a rated load
In this case the motor shall draw current more than the
rated valeu and run at a slightly less speed
Case 3.The motor is heavily loaded
In this case the motor shall stop running and chances of
burning of winding is very large
Case 4.The motor is stationary
In this situation the motor shall not start at all.
Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
What is a compensator?
Is potential difference materials property ..? if yes tnen how.. explain brifly.
Main advantage of auto transformer over two windings transformer is that A it needs no cooling B it uses only one winding C core losses are reduced D it has simple construction
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
What is the formula to calculate the no load current of a single & three phase induction motor
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
by what factor the starting current is used when comparing star and delta connection for motor starting?
How would your past experience translate into success in this job?
how desiel generate sart fail of eb?
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.