Interested to Buy Any Domain ? << Click Here >> for more details...
What makes the difference between 50Hz supply and 60Hz
supply which one is economical? What is the use of using
increased frequency?
- 5 Answers
- 10991 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / ekanadam patlavath
if frequency increases power losses decreases
viceversa.50hz econ0mical
| Is This Answer Correct ? | 7 Yes | 15 No |
Post New Answer View All Answers
what purpose to use excaiter in DG.?
explain the function of brush less dc motor?
Air circuit breaker safety
What is the role of power pack in substation protection system?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
Draw a block diagramof Three UPS systems connected in Parallel mode?
What is icu and ics in Acb and how many time icu or ics passes from breaker?
What are the causes for the failures of sandwich type (Al) busducts?
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
what does a string of resistors in a series will do?
What are the different methodes for calculating the short circuit Current?
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
