Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bejoy
As described above bt Fkexiraj the generator runs as motor
when the 2 alternator are in parallel ie synchronous
panel.The points of ramji is correct
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
pre arcing time of ehv breaker
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
application s to shunt coil
i am in need of AC SYNCHRONUS MOTOR 30KW. ANY ONE KNOWS THE MANUFACTURER OF SAME. ALSO MOSFET AC CONVERTER 20KVA CONT.OUTPUT.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
how does ELR works? explain
How to megger test 11 kV cable and the acceptance IR value
what is the meaning of osr in transformer.
gas turbine genrator reactances
how to select the isolation tranformer for siemens 802dsl cnotroller
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
