What will happen if we give DC supply to AC motor?
Answer Posted / mahavir jagdev
Passing DC current through the stator windings of an AC motor (I presume it to be a 3-phase one and all the three phases will have DC current passing) is like passing current through copper wires with very low resistance. Depending on the DC voltage applied and the stator resistor and it's insulation strength, either the DC source will get short circuited and if the fuse is of a larger rating then the stator winding will burn out. DC current will not produce any rotating magnetic field. Some what like what we call single phasing in 3 phase motors, when the stators burn out if one phase goes off and the rotor gets locked to the lack of the rotating magnetic field.
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
DG SET BLOCK DIGRAM
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
what happens if dc supply is given and the remedies for it.
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
what is sustainable current of any conductors . a bare busbar or pvc cable has different sustainable current .
On 400 amp factory load how kvarh capacitors provide
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
How to calculate the size of earth cable to earth the neutral of UPS ?
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
State the frequency for rc phase shift oscillator?
why US countries maintains 110v and 60HZ
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.