how bolometer is used in temperature measurement ??
Answer Posted / nish
bolometer is just a strip of metal having positive alpha...it can be used as any other resistive transducer
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
what is cems analyzer explain with principle and drawing ?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
kindly sent some demo question and answer
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
How will you calibrate PID controller? explain with example.
Capacitance, resistance ( colour coding ), parallel & series circuits.
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
How d.p. Transmitter can be applied to open tank?
pls give me presant awerness quistion and answer in my emailid.
There are many type of control cable like pair,core,tried, What are defination each one
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks