Interested to Buy Any Domain ? << Click Here >> for more details...
the power loss in an overloaded line is mainly due to?
a. resistance b. capacitance d. inductance
d. none
- 4 Answers
- 6427 Views
- I also Faced
- E-Mail Answers
Answer Posted / rao
Power loss is mainly due to resistance only.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the test block protection relay if any body know plz explained
what will be project cost for 100 kv transformer connection under oyt scheme.
Leakage current,un balance current which relay using for high voltage transmission?
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
How many kw will suply from one db
working principles of cf lamp,incandescentlamp and f lamp?
what is the difference between skin effect
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
The height to which the liquid in a tank to be maintained for a certain constant velocity?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
What is mason's gain formula?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
