Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between electrical & electronics
- 245 Answers
- 358603 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / zohaib
Electrical deals with high voltage and low
frequency.i.e:110V-440v and 50-60 Hz
also we can include the generation,transmission and
distribution in Electrical.
whereas Electronics deals with low voltage and high
frequency i.e:0-12V and in MHz or GHz frequency and it use
semiconductors for controlling of energy.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
What is the formula for calculating no-load current?
How would you calculate power loss in a resistor?
what is consequences of neutral and earth connect?
What does Bode plot tell you?
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
Can any body tell me the different types of LT cables & their application.
what is the difference b/w ground & virtual ground?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
what is the meaning of the symbol << >> put in transformer drawing
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
