What is Single Phasing fault???(not single-phase fault)
- 6 Answers
- 15926 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / falguni
if any one of 3 phases i.e. in r, y & b if r is not working
properly is called single phasing.
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
electrical knowelge
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
What is the difference between grid and off- grid system??
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
Rules and standards of electrical control wiring ?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
On what cycle does thermal power plant operate?
Discuss about gear cutting machines.
what is the saturation point of crgo lamination.
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
what are the 4 rules to start the motor?
What is a dominant pole?
