If I want to set a power plant in desert of ‘Rajasthan’ and
I have option of steam and gas power plant. Which plant I
should set up?
- 14 Answers
- 16574 Views
- DRDO, I also Faced
- E-Mail Answers
Answer Posted / himanshu swan
To set a power plant we need the availiablity of both fuel
and water or gas.
as in desert water is not abundant we should go for gas
power plant
but i would go for a solar plant.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
Which furnace burns low-ash fusion coal and retains most of the coal ash in the slag?
How do motion detectors work?
How to find ground in main switchboard?
what is the effect of throttle pressure on turbine efficiency?
What is the meaning of less pumping in AC
How would you increase the volume efficiency of centrifugal pump?
Enumerate the parts of Main Switchboard
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
SIR I M STUDENT OF POWER ENGG CAN I GIV PSU XAM 4 NTPC AND WHAT WOULD B THE PROCEDURE
At 50 Centigrade (Diesel oil) what is its cast?
Please advise your reasons for applying for this role and why you think you are suitable?
Please mail me the Satyam Computers (Mechanical Division, Satyam Technologies, Hyderabad & Bangalore) question papers on Design & strength of materials. Will be very thanksful.....srinivas_1704@yahoo.co.in
What is vane diagram in centrifugal pump?
How i injecter setting qsk series cummins engine and i can using click type torqurench or dial gauge type
Why can't we use antifrictional bearing in place of journal bearing in a 660mw plant
