Interested to Buy Any Domain ? << Click Here >> for more details...
Why is it preferred to use a wattmeter(s) to measure power
in three phase systems rather than using a combination of
other instruments e.g. voltmeters, ammeters etc?
- 2 Answers
- 6448 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravikumar.g
The wattmeter is using for find out the power in 3 phase
and single phase in differnet formulas.
In the voltmeter and ammeter reading can also find out the
power to caluculate the formulas.
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
what is mean by drives?
distribution is maximum done by a)radial b)network c) parallel d)b & c
In Indian Household, generally we receive 220V AC single phase supply. But AC has 2 phases, +ve & -ve. So in +ve half cycle current is flowing...so what happens in the -ve half cycle?? Please illustrate.
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
How can we calculate cable size in Low voltage & high voltage
What is the disadvantage in proportional controller?
How to decide whether A / B / C / D curve type MCB should be used?
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
why we need to us lenz's law for synchornous motor
What is the need of generator relay panel
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
how to flameproof electrical motor on the shaft?
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
what is proper capacitor placement? How to evaluate capacitor size?
