Interested to Buy Any Domain ? << Click Here >> for more details...
can you use 400 volt 3 phase and neutral and earth
equipment on 440 3 phase and earth supply safely and if so
how?
- 2 Answers
- 8226 Views
- Maersk, I also Faced
- E-Mail Answers
Answer Posted / phone
Maybe use conversion kit?
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
what percent do you derate your copper wire when you change from copper buss to copper wire
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
describe the phenomena of vacuum interruption in C.B
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
what is active power & reactive power?
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
What are chief characteristics of state-space method and its techniques ?
Define active and passive network?
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
why is control bus bi-directional?
