Interested to Buy Any Domain ? << Click Here >> for more details...
what is the procedure for cable sizing or on what basis we
will calculate the size of cable?????
- 6 Answers
- 22257 Views
- ANG, Focus, Mecon, I also Faced
- E-Mail Answers
Answer Posted / surendra matharu
I really appreciate the efforts put by all.
I would like to throw some light on the matter.
There are three CRITERIA for cable sizing :
The criteria which gives the worst rating is adopted.
1. The maximum short circuit current which can pass through
the cable.
2. The maximum load current which the load can withdraw from
the system.
3. The maximum voltage drop allowed in the system.
Out of these, whichever criteria gives higher rating, that
is selected.
Hope, this satifies the query.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
wat system call?
i need list of swg(standard wire guage) or area of conductor v/s current carrying capacity of conductor copper & alluminium...
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
What does Bode plot tell you?
placing earthing pit in pathway is correct or wrong??. placing earthing wireGI1/18 inside walls is correct or wrong?. explain!!!
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?
How to calculate the value of earth capacitance in a transmission line.
Define the term factor of inertia.
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
if we have 320KVA Genset kindly advice how much load we can put it.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What does a Bode plot tell you?
