Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anup ramteke
no 2 answer is correct but rather than recovery of pressure
it provides smooth recovery of fluid flow thus preventing
the turbulence in the flow and making it laminar.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
what is the difference between active & reactive power?
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
what are the selections available in configuring a burnout protection of a controller? thanks
Explain the working of an electronic level troll.
what is cold loop? difference between hot and cold loop?
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
What is offset in a control system.
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
what is the diffrence between pressure safety valve & pressure relief valve....pls
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
What is hp & mp seperator .& what is its working principle ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
