in transmission line 11kv is step up or step down? why?
Answer Posted / saravanan
*In transmission line 11kv is genrally step up,
because due to step up voltage (for example 220 kv,400 kv)
line current automatically goes down. Transmission line
travel is in KILO METER. To avoid the HEAT LOSS(I2R).
* If current is high, current carrying conductor
also change its size. so, cost also chaned in x'mission
system. So, we always used in high voltage low current
transmission system
Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
Where should the lighting arrestor be placed in distribution lines?
2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
what is the reactive power what is the use of it in system
What is the difference between rated and per unit in transformer?
how does this job compare with others you have aplied for?
mccb service sittings be done?
I am a electrical engg. diploma holder,applied for junior engineer (electrical),Kolkata RRB. Have I to attend all electrical,mechanical&civil portion in written exam.???
What type of core material is used for metering C.T and protection C.T???
what purose of the double circuit transmission line phase of the line phase changed for circuit-1 for Circuit-2 R-Y-B B-Y-R
How to convert 2 phase to 3 phase electricpower in induction moter?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
Classify milling machines.