Answer Posted / prakash gokhale
Power Factor is a cosine angle between voltage and current
Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
What are the reasons for the parallel operation of transformers?
why co incidence factor considered in transformer sizing?
can we find the inductance of a induction motor?
A d.c. Shunt motor is found suitable to drive fans because they require?
How the annunciator works ? How to do its wiring
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
How the over load setting for HT Motors calculated-provided in Numerical Relay
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
What type of pipe material G.I or M.S is used for sprinkler system?
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
describe the Operation of induction generators from bus bars
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
difference between the applicability of nortons and thevenin theorem