Interested to Buy Any Domain ? << Click Here >> for more details...
It is being often experienced that due to single phasing
fault of any source transmission line of any closed loop
synchronized circuit all the power transformers with
primary stared trips but the power transformer with primary
delta wont, why ?
- 1 Answers
- 4470 Views
- MSEB, I also Faced
- E-Mail Answers
Answer Posted / prakash gokhale
In stared primary transformer while single phasing the
neutral point gets unbalanced and result is system tripping.
While in delta primary tansformer neutral point is absent.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
difference between servo motor and synchronous motor
Explain how you decide what size of electrical wire do you need?
I am abt to give IOCL intrv.Plz sir guide me for IOCL intrvw (Electrical).Which subject to be consider. questions are generally asked from which subject.Plz help me out.
can we conduct the swineburne's test on a dc series motor? why?
What is a diode?
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
can we install HT panel & LT panel side by side or how much clearance is required ?
What is proportional controller?
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
explain supply side and demand side energy management with advantages & disadvantages
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
difine electrical ballast in HPSVL
