Interested to Buy Any Domain ? << Click Here >> for more details...
1)What will be full load current for 1000kva 3 phase
generator.
2)What will be full load current for 20Kva 1 phase inverter.
- 5 Answers
- 9745 Views
- I also Faced
- E-Mail Answers
Answer Posted / jay
1742A
90A
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
why u r living from presentaly working.
why do we not use equivalent voltage source in negative sequence equivalent ckt.
WHAT IS LOAD CELL
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
Which type of questions well asked. ?
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
How to calculate Voltage regulation of 22 KV Over head Line.
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
explain the functions of main isolation switches
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
