may anybody tell me the names of institute where plc
programing course are conducted
Answer Posted / c.r.shreedhar
Siemens offering the training on PLC, you may contact the
below said person for more details
MS.SHWETA SHAH
SIEMENS LTD.
Technical Skills Development Centre (TSDC)
Kalwa Works,
Thane Belapur Road,Thane
EMAIL ID: customer.training.in@siemens.com
PHONE NO: (022) 27623208 /27623566
FAX NO: (022)2762 3738
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
1.what is mean by 8/20 micro sec waveshape
Explain M Var? Which types of problem occurs when reactive power increase at the time of full load of plant and at the time of synchronize of plant?
What is meant by analogous system?
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
who can measure the size of power cable?
what is the cause of voltage dipp or swell in the transmission lines?
How may I enrol or get admission to your program?
1hp= how much rpm
When color of silica gel will gets change from blue to pink from Top to bottom?
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
errection check list for transformer maintenance
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
What is the mechanism of WTI