whats the one main difference between UPS & inverter ?
And electrical engineering & electronics engineering ?
Answer Posted / sripellirajukumar
Dear all .....
THIS IS sripellirajukumar again...
INVERTER AND UPS WORKS ON THE SAME PRINCIPLE......
UPS IS USED FOR ELECTRONIC PURPOSE
EX:(For computers ........)AND
INVERTER IS USED FOR ELECTRICAL PURPOSE EX:(fans...lighting
equipments)...........
Both are used when the power is not available..these all are
for backup purpose..........
| Is This Answer Correct ? | 2 Yes | 6 No |
Post New Answer View All Answers
define as synchronous generator
which types of relay used in acb and vcb?
How npn and pnp transistor works
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
How much voltage we need to apply in 33kv cable during hipot test of cable
How will you define capacitance?
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
how to set relay setting? and example calculation...
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
What are the basic properties of signal flow graph?
how to apply b license to c license in tneb
which type of stability limit is higher,steady state or transient? why?