how to consider the lap length of a bar in IS code.
- 7 Answers
- 9957 Views
- I also Faced
- E-Mail Answers
Answer Posted / silpa
60 times of the Dia For horizantal,
40 times of the Dia For vertical,
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
Civil engineering related
how to find hardness of water?why it should be determined?
As we know that steel is a tension member but why we are using STRUCTURE STEEL as a COLUMN (Without concrete) where column is a compression member and compression strength of steel is very low
How is the strength of cement measured?
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
a sewer which receives the discharge of no. of house sewer is called house sewer lateral sewer intrcepting sewer sub-main sewer
is basic cost of the material includes tax?
what r you reqired for concrete baching plant?
Can compresive strength test for concrete at 1 day age possible to carry out? If yes, which IS code describes the procedure for such testing?
I need Bhel engineertrainy test papers in civil engineering please send to email id - hisandy66@gmail.com
How many % we consider for lap for reinforcement for estimates
what is difference between GTS bench mark and temporary bench mark
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
what is the difference b/w full length and cutting length?
How to fix toll charge for a particular vehicle at toll booths in a highway?
