Interested to Buy Any Domain ? << Click Here >> for more details...
Why we choose 400kv,220kv,132kv,66kv,33kv transmission
voltages for transmitting power. Why not other voltage
levels.
- 21 Answers
- 62489 Views
- College School Exams Tests, HC, HCL, Jaypee, JPMorgan Chase, I also Faced
- E-Mail Answers
Answer Posted / abhijeet
You can chose any kind of voltage levels. but as per indian
standards these voltage levels are designed and all
equipment design are conforming to the standards. in
countries other than india there are different voltage
levels . it just like we r using 50 HZ and other countries
60 HZ frequencies. nothing hard and fast logic in selection
of voltage levels
| Is This Answer Correct ? | 9 Yes | 8 No |
Post New Answer View All Answers
Explain difference between stand by earth fault and residual earth fault protection?
What are the necessary components of the feedback control system?
hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
What are IR values and what it should be for coil and for insulator
what is transformor oil gread
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
plz tell me,ht and lt panel terminals in substations explain beiefly
